2.
CARD EDGE CONTROLS
2.1.
DETERMINING CURRENT IP ADDRESS SETTINGS
To read the current IP address during normal operation, press the toggle switch DOWN. The IP
address can be read on the four-character alphanumeric display.
2.2.
RESTORING FACTORY DEFAULTS
To restore all settings to factory defaults, apply power to the card while holding the toggle switch UP
until the green LED is illuminated.
2.3.
CARD EDGE LEDS
LED 22 is illuminated when Ethernet activity is detected.
All other card edge LEDs are for factory use only.
7700PTX-MVP Unidirectional UMD Protocol Translator
Red
Gr
P
T
X
Figure 2-1: PTX Card Edge
Revision 1.9
7700 MultiFrame Manual
7700PTX-MVP - 3