Displaying The Video Standard - evertz 7700 Manual

7700 Multi-Frame Manual
7707EO-HD SD/HD Re-Clocking Electrical to Fiber Converter
The EDH error display can only be enabled / disabled when there is a SMPTE 259M or SMPTE 344M
input signal.

4.2.3. Displaying the Video Standard

When the reclocker is enabled, the 7707EO-HD detects the Video standards of the signal present at its
input. To display the Video Standard, press the pushbutton one or more times until the STD message is
shown on the display. After one second the detected video standard will be shown. The following list
describes possible displays and their functions.
STD
N143
P177
N270
P270
N360
P360
N540
P540
HD
310M
BYP
LOS
7707EO-HD - 10
The following list describes the available selections.
SMPTE 259M-A, 143 Mb/s 4Fsc Composite NTSC
N143
SMPTE 259M-B, 177 Mb/s 4Fsc Composite PAL
P177
SMPTE 259M-C, 270 Mb/s 4:2:2 Component 525 line, 4:3
N270
SMPTE 259M-C, 270 Mb/s 4:2:2 Component 625 line, 4:3
P270
SMPTE 259M-D, 360 Mb/s 4:2:2 Component 525 line, 16:9
N360
SMPTE 259M-D, 360 Mb/s 4:2:2 Component 625 line, 16:9
P360
SMPTE 344M, 540 Mb/s 4:4:4 Component 525 line 4:3
N540
SMPTE 344M, 540 Mb/s 4:4:4 Component 625 line 4:3
P540
SMPTE 292M, 1.485 Gb/s
HD
SMPTE 310M
310M
Indicates reclocker is in non-reclock mode.
BYP
Indicates that no valid input signal is present.
LOS
Revision 1.5