Table of Contents
Advertisement
7700 MultiFrame Manual
7707OE-HD SD/HD Re-Clocking Fiber to Electrical Converter
2.
INSTALLATION
The 7707OE-HD comes with a companion rear plate that has three BNC connectors and one SC/PC
(shown), ST/PC or FC/PC optical connector. For information on mounting the rear plate and inserting the
module into the frame see section 3 of the 7700FR chapter.
OPTICAL INPUT
connectors. Accepts SMPTE 292M, SMPTE 259M, SMPTE 344M, DVB-ASI or SMPTE 310M
optical signals and provides auto-rate selection and reclocking for rates from 143Mb/s to
1.485Gb/s. A non-reclocking mode is also selectable via card edge jumpers, or through the
VistaLINK
®
accommodating standard CWDM or DWDM transmission schemes.
Do not hook up the 7707EO-HD DWDM cards and any 7707OE-HD series cards directly
with a short fiber optic cable. The 7707EO-HD DWDM card produces +7dBm of power,
which will damage the receiver if connected directly.
7707OE-HD-2
Figure 2-1: 7707OE-HD Rear Panel
Input for SDI optical signals. Available in SC/PC, ST/PC, FC/PC female
interface. This wide range input accepts optical wavelengths of 1270nm to 1610nm,
7707OE-HD
HD INPUT
HD OUTPUT
Revision 1.2.2
Advertisement
Table of Contents
