Table of Contents
Advertisement
Install the secondary riser cage blank
Procedure
1. Align the secondary riser cage blank to the rear panel.
2. Press down the secondary riser cage blank.
Make sure that the blank is firmly seated.
Install the riser cage
Procedure
1. If an expansion card or its internal cabling was removed, reinstall these components.
2. Install the riser cage:
a. Carefully press the riser down on its system board connector (callout 1).
Make sure that:
•
The riser cage is aligned with the rear chassis.
•
The riser board is firmly seated on the system board.
b. Simultaneously push and rotate the half-turn spring latch to 180° (callout 2).
c. Close the spring latch (callout 3).
Operations 54
Advertisement
Table of Contents
