Hitachi HA805 G3 Series User Manual page 154

5.
If you are installing a second M.2 SSD, repeat steps 2–4 on the slot 2.
Installing the M.2 pass-through card
6. Power down the server.
7.
If installed, open the cable management arm.
8.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
9.
Disconnect all peripheral cables from the server.
10. Remove the server from the rack.
11. Place the server on a flat, level work surface.
12. Remove the access panel.
13. Install the M.2 SSD pass-through card.
14. Do the following:
If you are installing the NVMe SSD, connect the P56691-001 signal cable to the system board.
•
If you are installing the SATA SSD, connect the P56690-001 signal cable to the system board.
•
Connect the M.2 SSD pass-through power cable to the system board.
•
15. Install the access panel.
16. Install the server into the rack.
17. Connect all peripheral cables to the server.
18. Connect the power cords:
Hardware options installation
153