Table of Contents
Advertisement
◦
T-10 Torx screwdriver
◦
Phillips No. 1 screwdriver—This tool is required only if the M.2 SSDs are not preinstalled on the boot device carriers.
About this task
CAUTION: A discharge of static electricity from a finger or other conductor might damage system boards or other
static-sensitive devices. To prevent damage, observe antistatic precautions.
Procedure
Installing drives onto the boot device
1.
Remove the boot device carrier:
a. Press and hold the carrier latch (callout 1).
b. Pivot the latch to open (callout 2).
c. Slide the carrier out from the boot device cage (callout 3).
2.
Install the SSDs on the boot device carrier:
a. Remove the SSD mounting screw.
b. Insert the SSD into the M.2 slot at a 45° angle (callout 1).
c. Carefully press the SSD down to the horizontal position (callout 2).
d. Install the SSD mounting screw (callout 3).
Hardware options installation
143
Advertisement
Table of Contents
