Table of Contents
Advertisement
Installing the boot device security cover in a preconfigured server
Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
About this task
In a preconfigured server that ships with the boot device already installed in the NS204i-u + secondary low-profile riser cage, the
accessory bag in the server box includes the security cover for the boot device. If you want to prevent hot-plug access to the
SSDs on the boot device, install this security cover.
Procedure
1.
Back up all server data.
2.
Power down the server.
3.
If installed, open the cable management arm.
4.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5.
Disconnect all peripheral cables from the server.
6.
Remove the server from the rack.
7.
Place the server on a flat, level work surface.
8.
Remove the access panel.
9.
Remove the NS204i-u + secondary low-profile riser cage:
a. Release the half-turn spring latch (callouts 1 and 2).
b. Lift the riser cage off the system board (callout 3).
Hardware options installation
148
Advertisement
Table of Contents
