Table of Contents
Advertisement
The installation is complete.
NS204i-u + low-profile riser cage option
The server supports the NS204i-u + low-profile riser cage with a PCIe5 x16 riser board that connects to secondary riser
connector. The PCIe5 x16 riser board supports a half-height, half-length (low-profile) expansion card.
The riser cage supports NS204i Boot Device that includes two 2280 M.2 NVMe SSDs.
Installing the NS204i-u + secondary low-profile riser cage
About this task
CAUTION: To prevent damage to electrical components, properly ground the server before beginning any installation,
removal, or replacement procedure. Improper grounding can cause electrostatic discharge.
Procedure
1.
Power down the server.
2.
If installed, open the cable management arm.
3.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4.
Disconnect all peripheral cables from the server.
5.
Remove the server from the rack.
6.
Place the server on a flat, level work surface.
7.
Remove the access panel.
8.
Remove the secondary riser cage blank.
9.
Remove the default secondary riser cage bracket.
Hardware options installation
120
Advertisement
Table of Contents
