Table of Contents
Advertisement
4.4. Change of bits
CAUTION
Always disconnect the screwdriver from air supply prior to
changing bits, to avoid the unintentional start of the
screwdriver, which may result in injuries.
Before exchange of bits, the clutch bearing has to be in
place.
1.
Unscrew the spring sleeve (left-hand thread) – only necessary if a finder
is mounted.
2.
After pulling the sleeve 351890 the bit may be removed or inserted.
Picture: Change of bits
IMPORTANT
Make sure to use perfect bits with DIN 3126 – E6,3 (1/4")
external hexagon end only.
16
Advertisement
Table of Contents
