Table of Contents
Advertisement
4.3. Change of bits
Attention:
Before exchange of bits, clutch bearing has to be in place and
driver needs to be disconnected from air supply.
To change bits, refer to picture Change of bits:
• Unscrew spring sleeve 364672 A (Accessories - Optional equipment) (left-
hand thread) – only necessary if a finder is mounted.
• Pull the lock sleeve 351890 forward, the bit can now be removed or
inserted.
Picture: Change of bits
4.4. Connection-Possibilities of the Function Control
• Use as air pressure outlet during screw-assembly:
to control driver start and stop, as well as shut-off control of clutch;
-
as cycle counter of the complete process;
-
each in connection with a PE- Switch or similar.
• Use as air pressure inlet:
if 6,3 bar (90 PSI) air pressure is given to the function control port,
-
the driver starts rotating at about 15 % of its speed. This will
simplify the engagement of bit/socket to fastener (for example
when driving hex screws, nuts, etc.)
14
Advertisement
Table of Contents
