Change Of Bits - Deprag MICROMAT 345-300-31U Operating Instruction Booklet

4.3. Change of Bits

ATTENTION
Change bits only, if air supply is disconnected and
clutch bearing is unscrewed.
· Remove spring sleeve 364670 A (left-hand thread) - only necessary if a
finder is mounted!
· Unscrew clutch bearing about 2,5 mm (3 rotations) (left-hand thread).
· Insert bit into the hex drive (drive-size: A3 DIN 3126) – bit locks
automatically.
· To remove the bit, push spindle 337290 into the driver.
· Assemble clutch bearing (left-hand thread).
Picture: Changing Bits
14