Table of Contents
Advertisement
4.3. Change of bits
Always disconnect the screwdriver from the air supply prior to
changing bits, to avoid the unintentional start of the screwdriver,
which may result in injuries.
1.
Unscrew the spring sleeve (left-hand thread) – only necessary if a finder
is mounted.
2.
After pulling the sleeve 351890 the bit may be removed or inserted.
sleeve
351890
Picture: Change of bits
Before exchange of bits, clutch bearing has to be in place.
Make sure to use perfect bits with DIN 3126 – E6,3 (1/4") exter-
nal hexagon end only.
15
Advertisement
Table of Contents
