Change Of Bits - Deprag 397066 A Operating Instruction Booklet

4.3. Change of Bits

CAUTION
Prior to changing bits, clutch bearing has to be in place and
screwdriver needs to be disconnected from air supply, to
avoid the unintentional start of the screwdriver which may
result in injuries.
IMPORTANT
Make sure to use perfect bits with DIN 3126 – E6,3 (1/4") exter-
nal hexagon end only.
To change bits, refer to picture Change of bits:
1. Unscrew the spring sleeve (Accessories - Optional Equipment) (left-hand
thread) – only necessary if a finder is mounted.
2. After pulling sleeve 351890 forward, the bit may be removed or inserted.
Put the bit into the hex until it locks!
Picture: Change of Bits
14