Table 3-4: General Feedback Connector Wiring (For Z Or T Axes) - Aerotech ECO225LM Hardware Manual

Electrical Specifications and Installation
Table 3-4: General Feedback Connector Wiring (for Z or T axes)
Pin Description
1 Signal shield connection
2 Over-Temperature Thermistor sensor
3 +5 V supply input for feedback devices
4 Reserved
5 Hall Effect sensor, phase B
6 Marker-N
7 Marker
8 Reserved
9 Reserved
10 Hall Effect sensor, phase A
11 Hall Effect sensor, phase C
12 Positive (CW) hardware limit
Reserved/Brake -
13
14 Cosine
15 Cosine-N
16 +5 V power supply
17 Sine
18 Sine-N
19 Reserved
20 Common ground to limit switch
21 Common ground to encoder power
22 Reserved
23 Reserved
24 Negative (CCW) hardware limit
Reserved/Brake +
25
1. BRAKE pins On Z or T axis, otherwise Reserved
Mating Connector
Backshell
Connector
30
(1)
(1)
Aerotech P/N
ECK00656
ECK00300
Chapter 3
ECO225LM Hardware Manual
Wire Gauge
2
AWG [mm ]
26 [0.129]
26 [0.129]
26 [0.129]
--
26 [0.129]
26 [0.129]
26 [0.129]
--
--
26 [0.129]
26 [0.129]
26 [0.129]
26 [0.129]
26 [0.129]
26 [0.129]
26 [0.129]
26 [0.129]
26 [0.129]
--
26 [0.129]
26 [0.129]
--
--
26 [0.129]
26 [0.129]
Third Party P/N
Amphenol 17-1726-2
Cinch DB-25S
www.aerotech.com
Connector