Rear Panel Description - EMS 5003 Operator's Manual

HIGH PERFORMANCE
WATER/OIL SEPARATOR
WITH MANUAL DRAIN
SAMPLE
HOSE CONN.
WATER SEPARATOR
PRE-FILTER
MANUAL DRAIN
WATER TRAP PRE-
FILTER W/ AUTOMATIC
DRAIN
Figure 3 shows the view from the back of the analyzer. The specific details of each
item are described below, starting from the upper left corner of the analyzer and working
clockwise.
Sample Hose Connection: The sample hose connection uses a quick disconnect
coupler. This is helpful for storage of the analyzer and maintenance of the sample hose.
The inlet is connected to a Oil/Water separator for pre-moisture extraction.
Display Control Switch: The display switch has two basic positions, Computer and
Display. The switch should normally be in the DOWN position "Display". If you are using
PC software for display or recording, the switch should be in the UP position. Note: The
switch direction is based upon you looking at the display. The switch should be
changed only with power turned off.
DB9 Computer Connection: This is used to connect the analyzer to your PC/laptop or
wireless antenna.
Power Cord: Connect to the appropriate voltage supply source.
Sample Air Exhaust: The analyzer discharges the sample air out these ports. Do not
plug..
Drain Hose: This hose will drain moisture collected during the sample process.
External Filter, Water Trap, Water/Oil Separator: This is the primary filtration system.
Filter maintenance will be discussed in the Maintenance section of this manual.
Water Separator Drain: Drain daily opening a ball valve.

Rear Panel Description

DRAIN
HOSE
Figure 3
COMPUTER
CONN.
SAMPLE AIR EXHAUST
EXTERNAL
FILTER
6
COMPUTER
MODE SWITCH
DB9
POWER
CORD