EMS 5003 Operator's Manual page 18

ETHERNET CONFIGURE SCREEN
The Ethernet configuration function allows you to connect to the net work and show the network IP
address. You can do this two ways:
1) DHCP is a automatic connection; Press the DHCP function, then press connect (Figure
34). The connect button will turn red for up to 30 sec.and once connected will be blue again. Press
Show IP to verify you are connected ( Figure 34).
2) Static is a manual connection for a data acquisition software that needs a specific IP
address to communicate. Press the static IP box to open the keypad screen ( Figure 35). Enter
your IP address press Ent to close. Press Netmask box and enter the Netmask value. Note: If
configuring a STATIC IP for Ethernet and there is NO Gateway, then enter 0.0.0.0 for Gateway
address. NOTE: After any WiFi configuration you must Restart the display from the Main Menu
button 8 shown on page 10 to access the IP address.
Figure 34
WIFI HOST MODE SCREEN
The WiFi Host mode function allows you to connect to the analyzer for a live reading on a device:
1) When WiFi Host mode is selected ( Figure 36), EMS1 will appear in the window as a
default name. You can change this name to what may be required for your shop. Press the WiFi
host box and a key pad will appear, clear or back space the default name and enter the new name
and press Ent. to close the key pad.
Figure 36
18
Figure 35