Setup Menu - EMS 5003 Operator's Manual

The Gas Analyzer SETUP screen has information and WiFi/Ethernet cable configuration functions
(Figure 33). The first 5 lines are information:
1) Version; Shows the version of display software on the display processor.
2) Serial #: IR Bench serial # and EMS ID.
3) PEF (LOW) Propane Equivalence Factor (PEF) for the analyzer. See calibration section
for expanded explanation.
4) PEF (HIGH) Propane Equivalence Factor (PEF) for the analyzer.
5) Activation Code: SN specific activation code, contact EMS for your code # if required.
The next 3 lines are for configuring different connections that will be explained further in the next
pages.
6) Ethernet: This configuration is for DATA Acquisition software interface.
7) WiFi Host Mode: EMS1 This is the live reading display WiFi interface.
8) WiFi Client Mode: This configuration is for DATA Acquisition software interface.
NOTE: After any WiFi configuration you must Restart the display from the Main Menu
button 8 shown on page 10.

SETUP MENU

Figure 33
17