Rear Panel Description - EMS 5001 Operator's Manual

Rear Panel Description

Figure 4
Figure 4 shows the view from the back of the analyzer. The specific details of each item
are described below, starting from the upper left corner of the analyzer and working clockwise.
Sample Hose Connection: The sample hose connection uses a quick disconnect
coupler. The is helpful for storage of the analyzer and maintenance of the sample hose.
Display Control Switch: The display switch has two basic positions, Computer and
Display. The switch should normally be in the lower position "Display". If you are using
PC software for display or recording, the switch should be in the up position. Note: If
the analyzer is not displaying gas values after warm-up, the display switch may
be in the computer position.
Computer Connection: This is used to connect the analyzer to the PC.
Power Cord: Connect to the appropriate voltage supply source.
Fresh Air Port: The analyzer uses this for fresh air sampling. Do not plug.
Drain Hose: This hose will drain moisture collected during the sample process.
External Filter: This is the primary sample filter. Filter maintenance will be discussed in
the Maintenance section of this manual.
Printer Connection: Connect to an approved parallel printer.
6