Computer Mode - EMS 5003 Operator's Manual

COMPUTER MODE SCREEN
If you are running the EMS LabView software, power down the analyzer and flip the toggle switch
in the back of the analyzer to computer mode (Figure 50). Connect your serial cables and power
up the analyzer to run the software. The display screen will show a message to " Disconnect from
computer" with a world pic while in computer mode (Figure 51). Note: If the display only shows "
Disconnect FROM COMPUTER " (Figure 51), check the "Display/Computer" switch on the back
of the analyzer. The switch should be in the right position for display mode.
Figure 50
Figure 51
22