Table of Contents
Advertisement
1
3
5
Figure 16 shows the control buttons on the MENU touch screen of the gas analyzer:
1.
The "CALIBRATION" button has one function.
a. Calibration of HC,CO,CO2,Nox.
2.
The "FUEL" button has one function.
a. Change the fuel type being tested to correct the AFR/LAMBDA formula.
3.
The "4 or 5 GAS" button has one function.
a. Changes the HOME screen to display 4 gases or 5 gases.
4.
The "LEAK CHECK" button is used to check for leaks inside the analyzer or the com-
plete analyzer and sample hose probe assembly..
5.
The "MAINTENANCE LOG" button allows you to enter a date of filter and sensor
change out.
6.
The "STATUS" is for viewing any error messages from the bench and sensors.
7.
The "SETUP" .button has several functions
a. Check the EMS display software version.
b. Check the bench SN.
c. Check bench PEF values; LOW and HIGH.
d. Enter the display software Activation code.
e. Ethernet cable configuration Data Acquisition interface.
f. Choose WiFi mode; Host mode: EMS live reading display interface.
g. Choose WiFi mode; Client mode: Data Acquisition interface
e. Access Status for ERROR message screen
8. The "RESTART" is for restarting the EMS processor for debugging in case of connection
problems so you don't power down the analyzer. Note: If you restart the processor and go back to
the Home screen, a Zero is required to establish bench communication. Note: Restart is
required after WiFi Host or Client mode is selcted.
MENU SCREEN
2
7
Figure 16
10
4
6
8
Advertisement
Table of Contents
