Siemens PELTON & CRANE Light Fantastic II Installation Instructions Manual page 83

D.
MODELS LFTII, LFTII-D ONLY
9 Pull out the dimmer control from the rear
knuckle (Figure 1). Remove the two wire
nuts that are attached to the two wires
coming from the front arm.
® Remove the stop screw and the set screw
in the arm mounting collar (Figure 1). Un-
screw the arm mounting collar from the
column (counterclockwise) as viewed
from below).
® Disconnect the two exposed mate-n-lok
connectors, which permits arm removal.
MODELS LFII, LFCII, LFCII-D ONLY
e Loosen the two set screws in the arm
adapter near the snubbing pins (Figure 8).
* Remove the top and bottom snubbing pin
and slide the front arm off the arm adapter.
ALL MODELS
e Reverse procedure for installing new arm.
NOTE: FOR ARM BALANCE ADJUST-
MENT, REFER TO LFil INSTAL-
LATION AND ADJUSTMENT IN-
STRUCTIONS, YL3-096035.
4. WIRING DIAGRAMS
White
Black
Green
27\25 vtsec)
o 9 Sreen Ground
| geek
o Black
© Cm Ἡ g | White
Ground
TROLLEY
PHASE CONTROL DIMMER CIRCUIT
Page 14
의
Ξ
Tal
3 gs
3) ğa)
인회 DIMMER SWITCH
JE SWITCH
2
[5—4
в
бои
Yellow
Black
LAMP
2 5
LFTII Track Light
TRANSFORMER BOX