Table of Contents
Advertisement
3.08 Replace Gas Spring in Track Mount Light
A.
Disconnect
all power to light.
B.
Pull
out dimmer
switch,
locate
and
remove
two wire nuts from wires leading from front
arm
(Figure
27).
REMOVE
WIRE NUTS-
DIMMER <
SWITCH
FIGURE
27 一 DISCONNECTING
WIRES
C. Pull out wires as shown in Figure 28,
LEAVE WIRES
AS SHOWN
FIGURE
28 一 REMOVING WIRES
Page
12
. Straighten
arm
as
in
Figure
29,
and
insert
gas tool (provided)
through
hole
in column
to engage
gas
spring.
Turn
counterclock-
wise until arm
tension
is relieved
(pressure
is released), plus four extra turns,
ARM MUST BE STRAIGHT
FIGURE
29—RELEASING
PRESSURE
ON GAS
SPRING
WARNING:
Ensure
pressure
has
been
re-
leased from gas spring.
. Remove four screws from underside of arm
shown in Figure 28.
. Punch out pin as shown in Figure 30, allow-
ing arm to come off (Figure 31).
NOTE:
Pin is designed
to permit removal or
insertion in one direction only. Push
from side with flats on pin.
Advertisement
Chapters
Table of Contents
