Siemens PELTON & CRANE Light Fantastic II Installation Instructions Manual page 58

ing (Figure 12). Press arm down to install two
front screws. Hold arm up to install two rear
screws (Figures 15 and 16).
CAUTION: All four screws on underside of arm must
be torqued to 40-inch pounds.
FIGURE 13 - REMOVING PIN
REAR KNUCKLE
REAR KNUCKLE
SUPPORT
FLAT END
MUST MATE WITH
SLOTTED TIE ROD
PIVOT PIN
TIE ROD ASSEMBLY
GUIDE ROD
N. For LFll's with plastic handles, insert hex
wrench into rear of arm and turn clockwise ap-
proximately eight turns once spring pressure
engages.
For LFil's with metal handles, insert hex
wrench into rear of arm and turn clockwise ap-
proximately 10-1/2 turns once spring pressure
engages.
LIFT UP ON KNUCKLE
WHILE PULLING DOWN
ON ARM.
KNUCKLE
FRONT
SCREWS
FIGURE 15 - INSTALLING TWO FRONT SCREWS
FRICTION
ADJUSTMENT
HOLE REAR SCREWS
~