Table of Contents
Advertisement
20
ADJUSTMENTS, continued
Adjustment
of Yoke Stop Position (For
Model
FCI,
LFCII-D, LETII,
LETII-D and LEWII-2
Determine stop position by rotating yoke
and head until it hits stop
8. To change position, loosen set screw A
in
side of yoke.
Rotate
yoke to desired
stop position.
Retighten set screw.
Knuckle Joint Adjustment (For Models LFII
Е
|
FWII-3
an
Il
9. Loosen two set screws B.
10. Rotate snubbing pins clockwise to increase
knuckle joint stiffness.
11. Rotate snubbing pins counterclockwise to
decrease knuckle joint stiffness.
NOTE: Flat side of snubbing pins ο
should always be in line with set screws
after completing adjustment as shown.
Retighten set screws.
12. Rotate head to position shown and remove
four screws D holding yoke cap in place.
Remove yoke cap.
13. Remove two screws E holding glass guard
to frame.
14. Push lever pin F in and remove reflector and
glass guard assembly. Do not lose pivot pin.
15. Lift out frame assembly. Loosen set screw G
on each side of frame.
16. Turn black pivot screw H clockwise to
increase stiffness. Turn counterclock-
wise to decrease stiffness.
17. Retighten set screws. Take care not to over-
tighten. End of screw should lightly rest
against flat side of black pivot screw.
Reinstall frame assembly, reflector, glass
guard assembly and cap, using care not to
pinch any electrical wiring.
Advertisement
Chapters
Table of Contents
