Table of Contents
Advertisement
©. Remount light head.
NOTE: Flat side
of snubbing
pins
should
face
set
screws.
P. Place yoke cap on yoke and check balance of
light.
Adjust
(using
t-handle
hex
wrench)
if
necessary,
turning
clockwise
to
increase
lift
force of arm or counterclockwise to decrease
lift force. The spring lift force is sensitive to
screw rotation
(use 1/4 turn increments) .~
NOTE: Equal
force
(or
up
to twice
as
much
force
DOWN)
should be required to move
light up
or down.
Q. Route
wires
back
through
arm
(as previously
installed,
ensuring
wires
are
in channels)
to
head,
replacing
plastic
sleeve
and
knuckle
cover. Do not pinch wires.
CAUTION:
Inspect rewiring carefully to prevent dam-
age to wire,
especially at arm joints.
R. Replace position screw
(Figure 7).
REMOVE
WIRE
NUTS
FIGURE
17 - DISCONNECT
WIRES
A. Disconnect
all power to light.
C. Locate and remove
two wire nuts from wires
leading from front arm
(Figure 17).
D. Remove
light head
with arm
by removing
two
screws at top of arm joint (Figure
18).
REMOVE
TWO
SCREWS
FIGURE 18 - REMOVING
LIGHT HEAD AND ARM
NOTE: Examine
position of wiring for reassembly.
E. Pull wires up through arm
and leave as shown
in Figure
19. Remove
position screw,
allowing
joint to straighten.
Pop
out
knuckle
cover
to
permit access to rear of arm.
F. Insert t-handle hex wrench
(not provided)
into
rear of arm
(refer to Figure 21 for hex wrench
insertion), and turn counterclockwise
until arm
tension is relieved, plus four extra turns.
WARNING: Ensure tension
has
been
released
from
gas spring.
G. Remove
four screws
from
underside
of arm
(Figure 12).
H. Punch
out
pin
and
remove
knuckle
(Figure
20).
NOTE: Pin is designed to permit removal or insertion
in one
direction
only.
Push
from
side
with
flats on pin.
41
Advertisement
Chapters
Table of Contents
