Siemens PELTON & CRANE Light Fantastic II Installation Instructions Manual page 44

e Remove autoclavable handles by grasp-
ing handles on either side, placing
thumbs underneath slides.
e Retract spring-loaded slides by pushing
thumbs outward and lift off handles.
e Grasp spare autoclavable handles on
either side, placing thumbs underneath
slides.
® Retract spring-loaded slides by pushing
thumbs outward,
e Position handles over frame and re-
lease slide, locking handles into place.
3.05 Cleaning and Sterilizing Autoclavable
Handles—Handles may be cleaned with a
soft cloth and mild detergent. Handles may be
safely sterilized using the following methods;
steam autoclaving, dry heat sterilization up to
320° F (160° C), ethylene oxide sterilization,
gamma radiation and cold sterilization.
CAUTION: SOME COLD STERILANTS
MAY DISCOLOR HANDLES
WITH USE OVER A PRO-
LONGED PERIOD OF TIME.
ADJUSTMENT
SCREWS
FIGURE 12 - ADJUSTMENT SCREWS
FOR FOCUSING LAMP
PATTERN A
PATTERNS PARTIALLY OVERLAPPED AND
ARE NOT FOCUSED FOR OPTIMUM PATTERN.
THIS PATTERN WILL "SHIFT" WHEN
PARTIALLY BLOCKED OUT.
PATTERN B
PATTERNS ARE SUPERIMPOSED.
FOR "OPTIMUM" PATTERN.
PATTERN WILL NOT SHIFT.
PATTERN C
IRREGULAR PATTERNS. ONLY
ONE ADJUSTING SCREW
SHOULD BE TURNED.
FIGURE 13 - FOCUSING LAMP
PATTERNS
Remove autoclavable handles to ac-
cess adjustment screws.
Turn two screws on front of light clock-
wise until both screws are tight. The
patterns will now be partially overlapped
as shown in pattern A in Figure 13.
Turn each screw counterclockwise
equally one turn at a time until the pat-
terns are superimposed as shown in
Pattern B in Figure 13.
Inspect for optimum pattern by blocking
out one half of the light. If the pattern,
appears to shift, further adjustment is
required. Otherwise, focusing of the.
lamp is completed.