Epson SC-P5300 Series User Manual page 29

SC-P5300 Series User's Guide
Item
I
Paper Feed Offset
J
Paper Eject Roller
K
Roll Core Diameter
L
Skew Reduction
M
Auto Cut
N
Paper Size Check
Introducing the Software
Function
Optimizes the paper feed when printing. By adjusting the gap between the data
size and the print size, you can reduce the chance of banding (horizontal banding)
or uneven colors.
Example of entering settings
When printing at a data size of 100 mm and a print size of 101 mm, the offset is 1.0
%. Therefore, you would enter a value of -1.0 %.
If the printing surface of the paper is scuffed, set a wider Platen Gap. If the results
still do not improve, try setting Paper Eject Roller to Use(Heavy Load), or
Use(Light Load). However, when using glossy paper, setting Paper Eject Roller to
Use (Heavy Load) or Use (Light Load) may damage the printable surface.
Set the paper core size for the roll paper being loaded.
Turn this off if the front edge of thin paper or soft paper folds.
When Follow Paper Source Settings is set, the printer operates according to the
On/Off setting for General Settings-Printer Settings-Paper Source Settings-Roll
Paper Setup-Cut Settings-Auto Cut on the menu of the control panel of the
printer.
Select this to automatically detect the width of the loaded paper.
29