Epson SC-P5300 Series User Manual page 103

SC-P5300 Series User's Guide
Setting item Set value
Drying Time Drying Time per Pass,
Drying Time per Page
Paper Size
On
Check
Auto Cut Follow Paper Source
Settings
Skew Reduc-
On
tion
Roll Core Diam- 2inch, 3inch
eter
Paper Eject
Auto
Roller
Use (Light Load), Do Not
Use
Paper Feed Off- -0.70 to +0.70 %
set
Restore Default Settings
Menu List
*
, Off
*
, Never Cut
*
, Off
Set the paper core size for the roll paper being loaded.
*
, Use (Heavy Load),
Explanation
You can set the drying time for each print head movement (pass) or
the drying time for each page.
Try setting it to Off if a paper width error is displayed even though
the paper is correctly loaded. However, we recommend that this
ordinarily be set to On. The changed settings are applied when you
reload the paper.
When Follow Paper Source Settings is set, the printer operates
according to the On/Off setting for General Settings-Printer
Settings-Paper Source Settings-Roll Paper Setup-Cut Settings-
Auto Cut.
Turn this Off if the front edge of thin paper or soft paper folds.
If the printing surface of the paper is scuffed, set a wider Platen
Gap. If the results still do not improve, try setting this function to
Use (Heavy Load) or Use (Light Load). However, when using
glossy paper, setting Paper Eject Roller to Use (Heavy Load) or
Use (Light Load) may leave marks on the printable surface.
This is displayed when Custom Paper is selected in Paper Type.
If banding (horizontal banding) or uneven colors occur, use this
function to do adjustments.
For example, when printing at a data size of 100 mm and a print
size of 101 mm, the offset is 1.0 %. Therefore, you would enter a
value of -1.0 %.
This is displayed when a Paper Type other than Custom Paper is
selected.
Restores all the setting conditions in Advanced Paper Settings to
their default settings.
103