Installer Manual Fleck 9000 - SXT - Maintenance
Valve produced from November 2009 until April 2015
Note
One of the seals contained in the cartridge will not be used for downflow.
Caution
For downflow, using this extra seal may damage the valve and its components.
Note
The seal & spacer cartridge for downflow and upflow are different. Upflow valves still have
the two pieces end cap and requires all the seals.
Caution
Use only approved silicone grease or soapy water.
No.
Remove the lower piston, see "Lower piston and/or front side seal and spacer kit
A
replacement", page 72.
Using a 8 mm wrench or flat screwdriver, unscrew (1) and remove the end cap (2)
B
(PN BR42278).
C
Using the puller, remove a spacer (5).
D
Using a small hook, remove a seal (4).
E
Repeat C and D for all the seals and spacers.
F
Lubricate all seals (4) with approved lubricant only.
G
Put back a new seal (4) using the stuffer.
H
Put back the new plain spacer (6) using the stuffer.
I
Put back a new seal (4) using the stuffer.
J
Put back a new spacer (5) using the stuffer.
K
Repeat I and J for all the seals and spacers.
L
Lubricate the end cap o-ring (3).
M
Put back the end cap (2) and screw (1) using a 8 mm wrench or flat screwdriver.
Put back the lower piston, see "Lower piston and/or front side seal and spacer kit
N
replacement", page 72.
76 / 108
Operation
Ref. MKT-IM-020 / B - 08.06.2018