Table of Contents
Advertisement
The following figure illustrates the two mounting options:
Grounding the NPort IA5000A Series
Grounding and wire routing help limit the effects of noise due to
electromagnetic interference (EMI). Run the ground connection from
the ground screw to the grounding surface before connecting the
devices.
ATTENTION
1. This product is intended to be mounted to a well-grounded
mounting surface such as a metal panel.
2. A 4 mm
external grounding screw is used.
Software Installation Information
For the NPort's configuration, the default IP address of the NPort is:
192.168.127.254. You may log in with the account name admin and
password moxa to change any setting to meet your network topology
(e.g., IP address) or serial device (e.g., serial parameters).
For software installation, download the relative utilities from Moxa's
website
https://www.moxa.com/support/support_home.aspx?isSearchShow=1
•
Download the NPort Windows Driver Manager and install it as the
driver to run with Real COM mode of the NPort Series.
•
Execute NPort Windows Driver Manager; then map the virtual COM
ports on your Windows platform.
•
You may refer to the DB9 Male pin assignment section to loop back
pin 2 and pin 3 for the RS-232 interface to carry out a self-test on
the device.
•
Use HyperTerminal or a similar program (you can download Moxa's
program, called PComm Lite) to test whether the device is good or
not.
2
conductor must be used when a connection to the
- 5 -
Advertisement
Table of Contents
