Table of Contents
Advertisement
PSoC™ 6 Wi-Fi Bluetooth® Pioneer Kit guide
CY8CKIT-062-WIFI-BT
Kit operation
35. Battery connector (J15, on the bottom side of the board): This connector can be used to connect a lithium-
ion polymer battery. Note that a battery is not included in the kit package and should be purchased separately
if you want to demonstrate battery charging.
36. USB PD output (J16): This header provides a voltage output when the USB Type-C power delivery system
receives power from an external host connected to J10. See
page 32 for more details.
See
"Hardware functional description"
For some devices in the PSoC™ 6 MCU family, simultaneous GPIO switching with unrestricted drive strengths and
frequency can induce noise in on-chip subsystems affecting CAPSENSE™ and ADC results. For more details, see
the Errata section of the corresponding
Table 5
shows the functionalities of the on-board selection switches.
Table 5
Selection switches on the Pioneer Board
Switch Location on the
board
SW5
Front
Note:
1. Starting with Rev. *F of the kit, the super capacitor is removed. Therefore, you must keep SW7 at VDDD/KITPROG3
position. If not, the kit will be unpowered, and you will notice flickering on the TFT display.
2. In the Rev *F version of the kit, the silkscreen on the board shows KitProg2. However, the KitProg3 is loaded on
the kit.
2.2
CY8CKIT-028-TFT details
2.2.1
CY8CKIT-028-TFT display shield
Figure 9
TFT display shield
User guide
on page 35 for details on various hardware blocks.
device
datasheet.
Purpose
Selects the V
supply of the PSoC™ 6 MCU between 1.8 V, 3.3 V,
DD
and the variable 1.8 V to 3.3 V, which is controlled by KitProg3.
"EZ-PD™ CCG3 Type-C Power Delivery"
25
on
Default
position
3.3 V
002-22677 Rev. *J
2023-12-18
Advertisement
Table of Contents
