Infineon CY8CKIT-062-WIFI-BT Manual page 14

PSoC™ 6 Wi-Fi Bluetooth® pioneer kit guide
CY8CKIT-062-WIFI-BT
Introduction
Table 1 Pioneer Board pinout (continued)
PSoC™ 6 pin Primary onboard
function
P10.5 GPIO on header
compatible with Arduino
J2.11, A5
PDM Data
P10.6 GPIO on non-Arduino
header (J2.13)
P10.7 Header J21.5
P11.0 FRAM CS
P11.1 RGB Blue LED
P11.2 QSPI FLASH CS
P11.3 QSPI FLASH DATA3
P11.4 QSPI FLASH DATA2
P11.5 QSPI FLASH DATA1
P11.6 QSPI FLASH DATA0
P11.7 QSPI FLASH CLK
P12.0 J3.4 on header
compatible with GPIO on
Arduino header, D11
SPI MOSI
P12.1 J3.5 on header
compatible with GPIO on
Arduino header, D12
SPI MISO
P12.2 J3.6 on header
compatible with GPIO on
Arduino header, D13
SPI CLK
P12.3 J3.3 on header
compatible with Arduino
P12.4 KitProg3 SPI SELECT
P12.5 PMOD SPI SELECT, J14.1
User guide
Secondary Connection details
onboard function
– –
– –
– –
GPIO on Connected to primary and secondary
non-Arduino functions by default. Remove R175 to
header (J18.8) disconnect from J18 and load R39 (10K) as
FRAM pull-up.
– –
GPIO on Populate R177 to connect to J18, remove R176
non-Arduino to disconnect from flash.
header (J18.7)
FRAM R17 need to be populated while using FRAM
FRAM R38 need to be populated while using FRAM
FRAM –
FRAM –
FRAM –
ICSP header (J5.4) Remove R77 to disconnect from KitProg3_SPI
and Pmod header lines.
(J14.2)
ICSP header (J5.1) Remove R85 to disconnect from KitProg3_SPI
and Pmod header lines.
(J14.3)
ICSP header (J5.3) Remove R81 to disconnect from KitProg3_SPI
and header lines.
compatible with
Pmod (J14.4)
– –
GPIO on Connected to primary function by default.
non-Arduino Populate R74 to connect to J19 or remove R83
header (J19.10) to disconnect KitProg3_SPI_SELECT.
GPIO on Connected to primary and secondary
non-Arduino functions by default. Remove R73 to
header (J19.9) disconnect from J19 or remove R82 to
disconnect
PMOD_SPI_SELECT.
14 002-22677 Rev. *J
2023-12-18