Table of Contents
Advertisement
PSoC™ 6 Wi-Fi Bluetooth® pioneer kit guide
CY8CKIT-062-WIFI-BT
Introduction
1
Introduction
Thank you for your interest in the CY8CKIT-062-WIFI-BT PSoC™ 6 Wi-Fi Bluetooth® Pioneer Kit. This kit enables you
to evaluate and develop your applications using the
The PSoC™ 6 MCU is an ultra-low-power PSoC™ device specifically designed for wearables and IoT products. It is
a programmable embedded system-on-chip, integrating a 150-MHz Arm® Cortex®-M4 as the primary application
processor, a 100-MHz CM0+ that supports low-power operations, 1024 KB flash 288 KB SRAM, CAPSENSE™
touch sensing, and programmable analog and digital peripherals that allow higher flexibility, in-field tuning of
the design, and faster time-to-market.
The PSoC™ 6 Wi-Fi Bluetooth® Pioneer Board offers compatibility with shields compatible with Arduino. The
board features a PSoC™ 6 MCU, a 512-Mb NOR flash, an onboard programmer/debugger (KitProg3), a 2.4-GHz
WLAN and Bluetooth® functionality module (CYW4343W), a USB Type-C Power Delivery system (EZ-PD™ CCG3), a
five-segment CAPSENSE™ slider, two CAPSENSE™ buttons, one CAPSENSE™ proximity sensing header, an RGB
LED, two user LEDs, USB host and device features, and one push button. The board supports operating voltages
from 1.8 V to 3.3 V for the PSoC™ 6 MCU.
The kit package includes a CY8CKIT-028-TFT display shield that contains a 2.4-inch TFT display, a motion sensor,
ambient light sensor, a 32-bit audio codec, and a PDM microphone.
You can use ModusToolbox™ software to develop and debug your PSoC™ 6 MCU projects. ModusToolbox™
software is a set of tools that enable you to integrate Infineon devices into your existing development
methodology.
If you are new to PSoC™ 6 MCU and Eclipse IDE for ModusToolbox™ software, see the application note
- Getting started with PSoC™ 6 MCU on ModusToolbox™ software
MCU and help you create your own design using the ModusToolbox™ software.
1.1
Kit contents
The kit package has the following contents, as shown in
•
PSoC™ 6 Wi-Fi Bluetooth® Pioneer Board
•
CY8CKIT-028-TFT display shield
•
USB Type-A to Type-C cable
•
Four jumper wires (4 inches each)
•
Two proximity sensor wires (5 inches each)
•
Quick start guide
Figure 1
Kit contents
User guide
PSoC™ 6
MCU.
to help you familiarize with the PSoC™ 6
Figure
1.
6
AN228571
002-22677 Rev. *J
2023-12-18
Advertisement
Table of Contents
