Infineon CY8CKIT-062-WIFI-BT Manual page 12

PSoC™ 6 Wi-Fi Bluetooth® pioneer kit guide
CY8CKIT-062-WIFI-BT
Introduction
Table 1 Pioneer Board pinout (continued)
PSoC™ 6 pin Primary onboard
function
P6.4 TDO/SWO
P6.5 TDI
P6.6 TMS/SWDIO
P6.7 TCLK/SWCLK
P7.0 TRACECLK
P7.1 CINTA
P7.2 CINTB
P7.3 GPIO on non-Arduino
header (J18.5)
P7.4 TRACEDATA[3]
P7.5 TRACEDATA[2]
P7.6 TRACEDATA[1]
P7.7 CMOD
P8.0 Proximity
P8.1 CAPSENSE™ Button0 Rx
P8.2 CAPSENSE™ Button1 Rx
P8.3 CAPSENSE™ Silder0 Rx
P8.4 CAPSENSE™ Silder1 Rx
User guide
Secondary Connection details
onboard function
– –
– –
– Remove R194 to disconnect from KitProg3
SWDIO.
– Remove R183 to disconnect from KitProg3
SWCLK.
GPIO on Populate R181 to connect to J18 header.
non-Arduino
header (J18.6)
– –
CSH Remove C31 (0.47 nF) and populate 10 nF for
CSH.
CSH Remove R146 to disconnect from header and
populate C29 (10 nF) for CSH.
GPIO on Populate R178 to connect to J18.
non-Arduino
header (J18.4)
GPIO on Populate R179 to connect to J18.
non-Arduino
header (J18.3)
GPIO on Populate R180 to connect to J18.
non-Arduino
header (J18.2)
GPIO on Populate R142 to connect to J18.
non-Arduino
header (J18.1)
GPIO on Populate R64 with zero ohm to connect to
non-Arduino header.
header (J20.1)
GPIO on Remove R61 to disconnect CAPSENSE™ pad
non-Arduino and populate R172 to connect to header.
header (J20.2)
GPIO on Remove R60 to disconnect CAPSENSE™ pad
non-Arduino and populate R166 to connect to header.
header (J20.3)
GPIO on Remove R53 to disconnect CAPSENSE™ pad
non-Arduino and populate R153 to connect to header.
header (J20.4)
GPIO on Remove R52 to disconnect CAPSENSE™ pad
non-Arduino and populate R152 to connect to header.
header (J20.5)
12 002-22677 Rev. *J
2023-12-18