Usb-To-Uart Bridge - Infineon CY8CKIT-062-WIFI-BT Manual

PSoC™ 6 Wi-Fi Bluetooth® Pioneer Kit guide
CY8CKIT-062-WIFI-BT
Kit operation
5. On the Web Server Demo – Home Page, enter your Wi-Fi network name and password of the non-enterprise
network directly or perform a Wi-Fi Scan to select the network you wish to use to connect to the cloud.
6. Once the device connection is successful, the TFT display is updated to show the Wi-Fi network name and the
URL to be used to view the sensor data.
7. Swipe your finger on the CAPSENSE™ slider to change the PWM duty cycle and LED8 brightness.
Figure 18 Use CAPSENSE™ slider to change PWM duty cycle and LED8 brightness
Note: If more than one kit is connected at the same time during OOB evaluation, the pre-programmed SSID
would be the same for all kits. Thus, it may be difficult to identify the kit with which the device has
established the connection. To avoid this scenario, reprogram each kit by changing the SOFTAP_SSID
macro in the web_server.h file.
2.3.2

USB-to-UART bridge

KitProg3 on the PSoC™ 6 Wi-Fi Bluetooth® Pioneer Kit can act as a USB-UART bridge.
The UART Rx and Tx pins of KitProg3 are connected to the PSoC™ 6 MCU UART pins as follows:
Figure 19 UART connection between KitProg3 and PSoC™ 6 MCU
For more details on the KitProg3 USB-UART functionality, see the
User guide
KitProg3 KitProg3
P12[6] P12[6]
P12[7] P12[7]
USB USB
P15[5] P15[5]
P1[6] P1[6]
RX RX
TX TX
P5[0] P5[0]
RX RX
TX TX
P5[1] P5[1]
CTS CTS
RTS RTS P5[2] P5[2]
RTS RTS
P5[3] P5[3]
CTS CTS
KitProg3 user
31
TM TM
PSoC PSoC 6 MCU 6 MCU
guide.
002-22677 Rev. *J
2023-12-18