Table of Contents
Advertisement
PSoC™ 6 Wi-Fi Bluetooth® Pioneer Kit guide
CY8CKIT-062-WIFI-BT
Kit operation
Note:
The TFT display operation at 1.8 V is currently not supported in this version of the kit. Ensure that the
following conditions are met when the CY8CKIT-028-TFT display shield is mounted on the PSoC™ 6
Wi-Fi Bluetooth® Pioneer Board.
1. Ensure that SW5 is either set to 3.3 V or set to the 1.8 V–3.3 V VARIABLE with PSoC™ Programmer selecting a
voltage of 2.5 V or higher.
2. If you want to erase the internal flash of the PSoC™ 6 MCU, ensure that the PSoC™ Programmer setting is not
1.8 V when the SW5 is set to the 1.8 V–3.3 V VARIABLE position.
2.3
KitProg3: On-board programmer/debugger
The PSoC™ 6 Wi-Fi Bluetooth® Pioneer Kit can be programmed and debugged using the KitProg3 onboard
programmer/debugger with USB-UART, USB-I2C, and USB-SPI Bridge functionality. KitProg3 supports CMSIS-
DAP and DAPLink mode for programming. A PSoC™ 5LP device is used to implement the KitProg3 functionality.
For more details on the KitProg3 functionality, see the
Note:
If you are using Rev *F or higher (see Kit Revision on the box), please note that the silkscreen of the kit
shows KitProg2 but KitProg3 is loaded on the kit.
2.3.1
Programming and debugging using ModusToolbox™ software
1. Connect the board to the PC using the provided USB cable through the KitProg3 USB connector, as shown in
Figure
11. The kit enumerates as a composite device when you connect it to your PC.
2. The KitProg3 on this kit is in CMSIS-DAP Bulk mode by default. The status LED (amber), LED2 and power LED
(amber), LED4 are turned ON at this time. If you do not see the desired LED status, see the
for details on the KitProg3 status and troubleshooting instructions.
Note:
Programming can be done in either KitProg3 programming modes, but it is recommended to program
the kit in CMSIS-DAP Bulk mode.
Figure 11
Connect USB cable to the USB connector on the board
User guide
KitProg3 user
guide.
27
KitProg3 user guide
002-22677 Rev. *J
2023-12-18
Advertisement
Table of Contents
