Expansion Connectors; Headers Compatible With Arduino (J1, J2, J3, J4, And J5); Psoc™ 6 Mcu I/O Headers (J18, J19, And J20); Psoc™ 5Lp Mcu Gpio Header (J6) - Infineon CY8CKIT-062-WIFI-BT Manual

Psoc 6 wi-fi bluetooth pioneer kit
Hide thumbs Also See for CY8CKIT-062-WIFI-BT:
Table of Contents

Advertisement

PSoC™ 6 Wi-Fi Bluetooth® Pioneer Kit guide
CY8CKIT-062-WIFI-BT
Hardware
3.2.6

Expansion connectors

3.2.6.1

Headers compatible with Arduino (J1, J2, J3, J4, and J5)

The board has five headers compatible with Arduino: J1, J2, J3, J4, and J5 (J5 is not populated by default). You
can connect 3.3-V shields compatible with Arduino to develop applications based on the shield's hardware. Note
that 5-V shields are not supported and connecting a 5-V shield may permanently damage the board. See
for details on the PSoC™ 6 MCU pin mapping to these headers.
3.2.6.2
PSoC™ 6 MCU I/O headers (J18, J19, and J20)
These headers provide connectivity to PSoC™ 6 MCU GPIOs that are not connected to the headers compatible
with Arduino. Most of these pins are multiplexed with on-board peripherals and are not connected to the PSoC™
6 MCU by default. For detailed information on how to rework the kit to access these pins, see
Bluetooth® Pioneer Board reworks"
3.2.6.3
PSoC™ 5LP MCU GPIO header (J6)
J6 is a 8 × 2 header provided on the board to bring out several pins of the PSoC™ 5LP MCU to support advanced
features such as a low-speed oscilloscope and a low-speed digital logic analyzer. This header also contains the
USB-UART, USB-I2C, and USB-SPI bridge pins that can be used when these pins are not accessible on the Arduino
headers because a shield is connected. The additional PSoC™ 5LP pins MCU are connected directly to the internal
programmable analog logic of PSoC™ 5LP MCU. J6 is not populated by default. Note that the SPI, RTS, and CTS
lines on these headers are directly from PSoC™ 5LP MCU (before level translator).
3.2.6.4

KitProg3 programming/GPIO header (J7)

A 5 × 2 header is provided on the board to bring out more PSoC™ 5LP MCU GPIOs. This header also brings out the
PSoC™ 5LP MCU programming pins and can be programmed using
connector. J7 is not populated by default.
Note:
In the Rev *F version of the kit, the silkscreen on the board shows KitProg2. However, the KitProg3 is
loaded on the kit.
User guide
on page 47.
41
MiniProg4
and a five-pin programming
Table 1
"PSoC™ 6 Wi-Fi
002-22677 Rev. *J
2023-12-18

Advertisement

Table of Contents
loading

Table of Contents