Infineon CY8CKIT-062-WIFI-BT Manual page 24

PSoC™ 6 Wi-Fi Bluetooth® Pioneer Kit guide
CY8CKIT-062-WIFI-BT
Kit operation
18. PSoC™ 6 MCU program and debug header (J11): This 10-pin header allows you to program and debug the
PSoC™ 6 MCU using an external programmer such as
PSoC™ 4, PSoC™ 5LP, or PSoC™ 6 device can be connected to this header and programmed using KitProg3.
19. CAPSENSE™ proximity header (J13): A wire can be connected to this header to evaluate the proximity
sensing feature of CAPSENSE™.
20. CAPSENSE™ slider (SLIDER) and buttons (BTN0 and BTN1): The CAPSENSE™ touch-sensing slider and two
buttons, all of which are capable of both self-capacitance (CSD) and mutual-capacitance (CSX) operation,
allow you to evaluate the CAPSENSE™ technology. The slider and buttons have a 1-mm acrylic overlay for
smooth touch sensing.
21. System power V selection switch (SW5): This switch is used to select the PSoC™ 6 MCU V
DD
between a constant 1.8 V, a constant 3.3 V, and a variable 1.8 to 3.3 V. In the variable 1.8 to 3.3 V mode, the
PSoC™ Programmer software can control the voltage via KitProg3.
22. 512-Mbit serial NOR flash memory (S25FL512S, U4): The
connected to the serial memory interface (SMIF) of the PSoC™ 6 MCU. The NOR device can be used for both
data and code memory with execute-in-place (XIP) support and encryption.
23. PSoC™ 6 MCU user LEDs (LED8 and LED9): These two user LEDs can operate at the entire operating voltage
range of PSoC™ 6 MCU. The LEDs are active LOW, so the pins must be driven to ground to turn ON the LEDs.
24. RGB LED (LED5): This on-board RGB LED can be controlled by the PSoC™ 6 MCU. The LEDs are active LOW, so
the pins must be driven to ground to turn ON the LEDs.
25. Wi-Fi and Bluetooth® module (LBEE5KL1DX-883, U6): This kit features the on-board Wi-Fi and Bluetooth®
combination module to demonstrate the IoT features. LBEE5KL1DX is a Type 1DX module available with
2.4-GHz WLAN and Bluetooth® functionality. Based on Infineon AIROC™ CYW4343W Wi-Fi & Bluetooth® combo
chip, this module provides high-efficiency RF front-end circuits.
26. 4-Mbit serial F-RAM (CY15B104QSN, U5): This kit contains the CY15B104QSN
4-Mbit (512K × 8) Excelon™ F-RAM device, which can be accessed through the Quad SPI interface, which is
capable of Quad SPI speed up to 108 MHz but PSoC™ 6 MCU is limited to 80 MHz.
27. Wi-Fi-Bluetooth® antenna (ANT1): This is the on-board antenna connected to the Wi-Fi and Bluetooth®
module.
28. VBACKUP and PMIC control selection switch (SW7, on the bottom side of the board): This switches the
VBACKUP supply connection to the PSoC™ 6 MCU between VDDD/KITPROG3 and the SUPER CAP/PSOC™ 6.
Note: Starting with Rev. *F of the kit, the super capacitor is removed. Therefore, you must keep SW7 at
VDDD/KITPROG3 position. If not, the kit will be unpowered, and you will notice flickering on the TFT
display.
29. PSoC™ 6 USB Type-C connector (J28): The USB cable provided with the PSoC™ 6 Wi-Fi Bluetooth® Pioneer
Kit can also be connected between this USB connector and the PC to use the PSoC™ 6 MCU USB device
applications.
30. PSoC™ 6 MCU (CY8C6247BZI-D54, U1): This kit is designed to highlight the features of the PSoC™ 6 MCU.
For details on PSoC™ 6 MCU pin mapping, see
31. PSoC™ 6 USB Type-A connector (J27): USB devices can be connected to this USB Type-A connector and
communicate with the PSoC™ 6 MCU USB host applications.
32. ICSP header compatible with Arduino (J5): This header provides an SPI interface for shields compatible
with Arduino ICSP.
33. PSoC™ 6 MCU current measurement jumper (J8, on the bottom side of the board): An ammeter can be
connected to this jumper to measure the current consumed by the PSoC™ 6 MCU.
34. KitProg3 (PSoC™ 5LP) programmer and debugger (CY8C5868LTI-LP039, U2): The
PSoC™ 5LP device (CY8C5868LTI-LP039) serving as KitProg3, is a multi-functional system, which includes a
programmer, debugger, USB-I2C bridge, USB-UART bridge, and a USB-SPI bridge. For details, see the
KitProg3 user guide.
User guide
MiniProg3 / MiniProg4. In addition, an external
S25FL512S
Table 1.
24
supply voltage
DD
NOR flash of 512Mb capacity is
002-22677 Rev. *J
2023-12-18