Table of Contents
Advertisement
PSoC™ 6 Wi-Fi Bluetooth® pioneer kit guide
CY8CKIT-062-WIFI-BT
Introduction
Table 1
Pioneer Board pinout (continued)
PSoC™ 6 pin
Primary onboard
function
P12.6
ECO IN
P12.7
ECO OUT
P13.0
GPIO on header
compatible with Arduino
J3.1, D8
P13.1
GPIO on header
compatible with Arduino
J3.2, D9
P13.2
USB HOST EN
P13.3
USB_INT_L
P13.4
USB_DEV_VBUS_DET
P13.5
GPIO on non-Arduino
header J21.8
P13.6
GPIO on non-Arduino
header J2.19
P13.7
User LED (red)
1.3.2
CY8CKIT-028-TFT board details
Figure 4
shows the thin-film transistor (TFT) display shield that has the following features:
•
A 2.4-inch TFT LCD module with 240 × 320 pixel resolution.
•
A three-axis acceleration and three-axis gyroscopic motion sensor.
•
A PDM microphone for voice input.
•
A 32-bit stereo codec with microphone, headphone, and speaker amplifier capability.
•
An audio jack with a provision of connecting both AHJ and OMTP headphones. The headset standard can be
set by an on-board switch.
•
An ambient light sensor IC made of an NPN phototransistor.
•
An LDO that converts 3.3 V to 1.8 V for the digital supply of the audio codec.
User guide
Secondary
Connection details
onboard function
GPIO on
Conne
non-Arduino
header (J19.8)
GPIO on
–
non-Arduino
header (J19.6)
–
–
–
–
GPIO on
–
non-Arduino
header (J21.2)
GPIO on
–
non-Arduino
header (J21.4)
GPIO on
–
non-Arduino
header (J21.6)
–
–
CAPSENSE™ shield Remove R44 to disconnect from GND and
populate R45 to connect to the CAPSENSE™
shield (hash pattern on the board).
GPIO on
Remove R31 to disconnect from LED.
non-Arduino
header (J2.20)
15
002-22677 Rev. *J
2023-12-18
Advertisement
Table of Contents
