Canon EOS C300 Mark II Instruction Manual page 135

Menu items
[Saturation]
[Slope]
Input
[Point]
Input
[Sharpness]
[Level]
[Detail Frequency]
[Coring Level]
[Limit]
[Noise Reduction]
[Spatial Filter]
[Frame Correlation]
[Skin Detail]
[Effect Level]
[Hue]
[Chroma], [Area], [Y Level]
[Color Matrix Tuning]
[Gain]
–10 to +10 (±0)
These settings control the upper part of the gamma curve (highlights of the image). By compressing
the highlights, you can prevent parts of the image from being overexposed.
[Slope]: Determines the slope of the gamma curve above the knee point.
[Point]: Sets the knee point of the gamma curve.
[Saturation]: Adjusts the color saturation in the highlights.
–10 to +50 (±0)
Sets the sharpness level of the video output signal and the recorded signal.
–8 to +8 (±0)
Sets the center frequency of horizontal sharpness. Setting higher values increases the frequency,
which, in turn, increases the sharpness.
–30 to +50 (±0)
Sets the level of correction of artifacts caused by high sharpness levels (coring). Higher values
prevent sharpness from being applied to minute details, resulting in less noise.
–50 to +50 (±0)
Restricts how much sharpness is applied.
[Off], 1 to 12
[Off], 1 to 12 (1)
Reduces noise by applying a soft focus-like effect on the entire picture. When set to a value other
than [Off], afterimages are not produced but the whole image will have a softer look.
[Off], 1 to 3
Reduces noise elements by comparing the current image to the previous one (field). When set to a
value other than [Off], the perceived resolution will not be affected but an afterimage may appear for
moving subjects.
[Off], [Low], [Middle], [High]
–16 to +16 (±0)
0 to 31 (16)
The camera applies a softening filter to areas in the picture with skin tones to give a more pleasant
appearance. By changing these settings, you can determine what areas will be detected as skin
tones. A zebra pattern will appear on the screen over areas of the image that are detected as having
skin tones.
[Effect Level]: Adjusts the level of the filter.
[Hue]: Adjusts the hue for detection of skin tones.
[Chroma]: Adjusts the color saturation for detection of skin tones.
[Area]: Adjusts the color range for detection of skin tones.
[Y Level]: Adjusts the brightness for detection of skin tones.
–50 to +50 (±0)
Options / Additional information
Custom Picture Settings
135