Recording; Recording Video And Photos - Canon EOS C300 Mark II Instruction Manual

3

Recording Video and Photos

This section explains the basics of recording clips* and photos. For details on recording audio, refer to
Audio
(A 102).
* "Clip" refers to a single movie unit recorded with a single recording operation. You can also include metadata with the clip.

Recording

1 Set the Q switch to CAMERA.
• The camera turns on in CAMERA mode and enters record standby mode ([STBY]).
• The power indicator (rear tally lamp) will illuminate in green.
• The access indicators of card slots with a card inserted will illuminate momentarily in red. Then, the access
indicators of cards selected for recording will change to green.
2 Press the REC button to begin recording.
• Recording starts. The tally lamps illuminate in red (the rear tally lamp changes from green (power indicator) to
red) and the recording indicator at the top of the screen changes from [STBY] to [ÜREC].
• The access indicator of cards used for recording will illuminate in red.
• You can use the REC button on the camera or the one on the camera grip.
• You can also perform this function remotely using Browser Remote on a connected network device (A 183,
187).
• For details about recording proxy clips, refer to
3 Press the REC button to stop recording.
• The clip is recorded and the camera enters record standby mode. The front tally lamp goes out and the rear
tally lamp changes from red to green (power indicator).
• The access indicator of cards selected for recording will change back to green.
Power indicator/
rear tally lamp
SD card access
indicator
CFexpress card
access indicators
Proxy Clips (Simultaneous Recording)
Recording
Front tally lamp
(A 66).
51
Recording