Locate And Install - Graco PSM Instructions Manual

Locate and Install

1. The PSM Machine (H, page 7) can be directly
mounted on a Customer Robot (G, page 7) or
remotely mounted on a motion table. Verify the
location has access to compressed air and AC
power.
3.190 in.
(81 mm)
F . 4: Mounting Hole Dimensions for Installing the PSM Machine - 25cc
IG
3.583 in.
(91 mm)
F . 5: Mounting Hole Dimensions for Installing the PSM Machine - 50cc
IG
3A7273B
2. Place the PSM Machine (H, page 7) onto the
3. Attach the PSM Installation Plate (AC, page 8) to
2 x Ø0.315 in. (8.0 mm) Through
2.756 in.
(70 mm)
5.512 in.
(140 mm)
2.756 in.
(70 mm)
3.740 in.
(95 mm)
designated location.
the selected location by installing fasteners (not
provided with the PSM machine) through the four
mounting holes. There are also two position pin
holes. Refer to F . 4, F
IG IG
hole dimensions.
4 x Ø0.335 in. (8.5 mm) Through
2 x Ø0.315 in. (8.0 mm) Through
4 x Ø0.335 in. (8.5 mm) Through
General Information
. 5 or F . 6 for mounting
IG
3.190 in.
(81 mm)
3.583 in.
(91 mm)
11