Table of Contents
Advertisement
CHAPTER 3 |
Energize/De-energize
Using The Arm Feature
In this screen you also have the option to Energize or De-energize the outputs.
The Disarm Outputs status screen returns. The components that were selected are
listed in the Components section of the screen (See Figures 3-10a and 3-10b.) In this
example for a DLC device, the Component is Relay 1, and the Output is De-Energized.
For the MLC device, the Component is All Outputs and the Output is De-Energized.
Menu:Maint:Control:Disarm
PHY:FireFinder@1, DLC@1, HFP11@2
DISARM OUTPUTS
AT: FireFinder@1, DLC@1, HFP11@2
COMPONENTS: Relay 1
OUTPUT:
De-Energized
Cancel
Settings
Figure 3-10a
Disarm Outputs Status Screen - DLC
At this point, the components that were selected are not yet disarmed.
Press the Execute soft key to disarm the selected components.
When the devices are disarmed, a trouble reports on the system indicating exactly
what has been disarmed and the Partial System Disable LED glows steady yellow.
Navigate to the desired device using the More Info/+ and — (PMI-1) or
PMI-3) buttons, select the Control option by pressing the Control soft key and then
Touch the box labeled Arm.
The Arm Devices screen displays showing the location (In this example, AT:
FireFinder@1, DLC@1, HFP11@2). See Figure 3-11.
Menu:Maint:Control:Arm
PHY:FireFinder@1, DLC@1, HFP11@2
ARM DEVICES
AT: FireFinder@1, DLC@1, HFP11@2)
10:53
Category text information
Cancel
Settings
Figure 3-11
Arm Devices Screen
To arm all elements associated with the device, press the Execute soft key.
PMI OPERATION MANUAL
Menu:Maint:Control:Disarm
PHY:FireFinder@1, MLC@2, FP11@2
AT: FireFinder@1, MLC@2, FP11@2
COMPONENTS: All Outputs
OUTPUT:
De-Energized
Cancel
Settings
Execute
Figure 3-10b
Disarm Outputs Status Screen - MLC
Execute
MAINTENANCE MODE
DISARM OUTPUTS
Execute
(PMI-2/
3-7
Advertisement
Table of Contents
