Asd - Siemens FIREFINDER-XLS PMI Operation Manual

PMI OPERATION MANUAL
Bypass ASD
Enable ASD
Change ASD
MAINTENANCE MODE
3-10
Change ASD can only be performed at the device level (Physical view) and Bypass
ASD can only be performed at the module (DLC or MLC) level. These operations will
appear grayed out on the PMI when the system is set at any other level.
Press the Control soft key. [If the appropriate level password has not been previously
entered or if it has timed out, the Enter Password screen displays. (See page 3-1.)]
The Control menu displays. Touch the desired operation to either bypass, enable or
change the ASD setting.
Touch the box labeled Bypass ASD and a screen displays showing the number of
devices that will be bypassed. See Figure 3-16.
At this point, the ASD setting has not been bypassed.
Menu:Maint:Control:BypassASD
PHY:FireFinder@1, DLC@3
BYPASS ASD
AT: FireFinder@1, DLC@3
# ASD Devices: 63
10:53 Category text information
Cancel
Figure 3-16
Bypass ASD Status Screen
Press the Execute soft key to bypass the ASD setting.
To Enable ASD, follow the steps above in Bypass ASD, selecting the Enable setting
instead of the Bypass setting.
To Change the ASD settings, you must first navigate to the device level using the
More Info/+ button. Then follow the steps above in Disable ASD, selecting the
Change ASD setting instead of the Disable setting. Press the Settings soft key to
display all the possible ASD settings. The current ASD setting is highlighted. See
Figure 3-17 .
Menu:Maint:Control:ChangeASD:Settings
PHY:FireFinder@1, DLC@1
Disable Office Warehouse
Computer room Dormitory Healthcare
Utility room Precious storage Hostile Env
Cancel OK
Figure 3-17
Change ASD Setting
Execute
Lobby
Garage
Duct
| CHAPTER 3