Siemens FIREFINDER-XLS PMI Operation Manual page 42

CHAPTER 3 |
Outputs
Control - ASD
When the box labeled Outputs is selected for DLC devices, the components section
of the screen displays the items that can be chosen. When the Outputs box is
selected for MLC devices, no components are available for individual selection—if
Outputs is selected, all MLC outputs are included. See Figure 3-14a for DLC devices
and 3-14b for MLC devices. Items that can not be chosen are grayed out. (In Figure 3-
14a, LED is grayed out.) Make a selection of the components you wish to arm, then
press the OK soft key.
The Arm Output feature is not available for VESDA detectors. The PMI has no control
over the VESDA output relays. There are no Arm Output menus for VESDA detectors.
Menu:Maint:Control:Arm:Settings
PHY:FireFinder@1, DLC@1, HFP11@2
Apply To
Devices Inputs
Components
Relay 1 LED
Cancel OK
Figure 3-14a
Arm Outputs Settings - DLC
At this point, the components that were selected are not yet armed.
The Arm Outputs status screen returns. See Figures 3-15a and 3-15b. The compo-
nents that were selected are listed in the Components section of the screen. In
Figure 3-15a, the component is Relay 1; in Figure 3-15b, they are All Outputs. Press
the Execute soft key to arm the selected component.
Menu:Maint:Control:Arm
PHY:FireFinder@1, DLC@1, HFP11@2
ARM OUTPUTS
AT: FireFinder@1, DLC@1, HFP11@2
COMPONENTS: Relay 1
Cancel Settings
Figure 3-15a
Arming Selected Outputs - DLC
While in the Maintenance mode, navigate to the desired module/loop or device by
pressing the More Info/+ or — (PMI-1) or
PMI OPERATION MANUAL
Menu:Maint:Control:Arm:Settings
PHY:FireFinder@1, MLC@2, FP11@2
Apply To Devices
Outputs
Cancel OK
Figure 3-14b
Arm Outputs Settings - MLC
Menu:Maint:Control:Arm
FireFinder@1, MLC@2, FP11@2
AT: FireFinder@1, MLC@2, FP11@2
COMPONENTS: All Outputs
Cancel Settings
Execute
Figure 3-15b
Arming Selected Outputs - MLC
(PMI-2/PMI-3) buttons.
MAINTENANCE MODE
Inputs Outputs
ARM OUTPUTS
Execute
3-9