Siemens FIREFINDER-XLS PMI Operation Manual page 41

PMI OPERATION MANUAL
Inputs
MAINTENANCE MODE
3-8
To select individual components associated with the device, press the Settings soft key.
Touch the desired Devices, Inputs or Outputs box to select it. See Figure 3-12. This
screen is context-sensitive and will allow you to select only those items which are
applicable. (If you select the wrong item, touch the box you wish to select.)
Maint:Control:Arm:Settings
PHY:FireFinder@1, DLC@1, HFP11@2
Apply To
Devices Inputs
Components
Smoke/Photo Switch 1
Thermal Neural
Cancel OK
Figure 3-12a
Arm Inputs Settings - DLC
When the Inputs box is selected for DLC devices, the components section of the
screen displays the items that can be chosen. When the Inputs box is selected for
MLC devices, no components are available for individual selection—if Inputs is
selected, all MLC inputs are included. See Figure 3-12a for DLC devices and 3-12b for
MLC devices. Items that can not be chosen are grayed out. (In Figure 3-12a, Switch 1
and Switch 2 are grayed out.) Make a selection of the components you wish to arm,
then press the OK soft key.
At this point, the components that were selected are not yet armed.
The Arm Inputs status screen displays. See Figures 3-13a and 3-13b. The compo-
nents that were chosen are now listed in the Components section of the screen. In
Figure 3-13a, they are Smoke/Photo, Thermal; in Figure 3-13b, they are All Inputs.
Press the Execute soft key to arm the selected components.
Menu:Maint:Control:Arm
PHY:FireFinder@1, DLC@1, HFP11@2
ARM INPUTS
AT: FireFinder@1, DLC@1, HFP11@2
COMPONENTS: Smoke/Photo, Thermal
Cancel Settings
Figure 3-13a
Arming Selected Inputs - DLC
Maint:Control:Arm:Settings
PHY:FireFinder@1, MLC@2, FP11@2
Outputs Apply To
Devices
Switch 2
Cancel
Figure 3-12b
Arm Inputs Settings - MLC
Menu:Maint:Control:Arm
PHY:FireFinder@1, MLC@2, FP11@2
AT: FireFinder@1, MLC@2, FP11@2
COMPONENTS: All Inputs
Cancel Settings
Execute
Figure 3-13b
Arming Selected Inputs - MLC
| CHAPTER 3
Inputs Outputs
OK
ARM INPUTS
Execute