12
SERVICE WORK ON THE CHASSIS
12.9
Removing the lower triple clamp
12.10
Removing the lower triple clamp
–
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front brake caliper
–
Mount the cable tie(s).
–
Position the brake line, wiring harness, and clamp. Mount and tighten screws
E00375-11
Finishing work
–
Install the front wheel.
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
(All standard EXC/XC-W models)
Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Remove the front wheel.
–
Remove the headlight mask with the headlight. (
–
Remove the fork legs.
–
Remove the front fender. (
–
Remove the handlebar cushion.
Main work
–
Remove screw
dlebar and hang it to one side.
Info
Protect the components against damage by covering them.
Do not bend the cables and lines.
V00336-10
–
Remove O-ring
–
Take off the lower triple clamp with the steering stem.
–
Remove the upper steering head bearing.
V00335-10
(All Six Days models)
Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Remove the front wheel.
–
Remove the headlight mask with the headlight. (
–
Remove the fork legs.
–
Remove the front fender. (
–
Remove the handlebar cushion.
M8
(
p. 85)
p. 97)
(
p. 85)
(
p. 52)
p. 60)
. Loosen screw
. Pull off the upper triple clamp with the han-
. Remove protective ring
(
p. 85)
(
p. 52)
p. 60)
.
25 Nm
Loctite
(18.4 lbf ft)
p. 95)
p. 51)
p. 94)
.
p. 51)
p. 94)
54
®
243™
.