15
ELECTRICAL SYSTEM
15.8
Changing the turn signal bulb (All EXC/EXC Six Days models)
Note
Damage to reflector Reduced brightness.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease
before mounting.
Main work
–
Turn protection cap
all the way and remove it.
–
Pull bulb socket
E00358-10
–
Pull out headlight bulb
–
Insert the new headlight bulb.
Headlight (HS1/socket BX43t) (
–
Insert the protection cap with the bulb socket into the reflector and turn it clock-
wise all the way.
Info
Ensure that O-ring
E00359-10
–
Insert the bulb socket of the parking light into the reflector.
Finishing work
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
Main work
–
Remove the screw on the rear of the turn signal housing.
–
Carefully remove turn signal glass
–
Lightly squeeze orange cap
–
Press the turn signal bulb lightly into the socket, turn it counterclockwise by about
30°, and take it out of the socket.
Info
Do not touch the reflector with your fingers and keep it free from grease.
–
Press the new turn signal bulb carefully into the socket and turn it clockwise until
it stops.
Turn signal (R10W / socket BA15s) (
–
Mount the orange cap.
–
Position the turn signal glass.
–
Insert the screw and first turn counterclockwise until it engages in the thread with
a small jerk. Tighten the screw lightly.
E00360-10
Finishing work
–
Check that the turn signal system is functioning properly.
together with the underlying bulb socket counterclockwise
of the parking light out of the reflector.
.
p. 127)
is seated properly.
p. 97)
.
in the area of the holding lugs and take it off.
p. 127)
p. 95)
96