Changing The Gear Oil - Husqvarna 125 XC-W 150 2017 Owner's Manual

18 SERVICE WORK ON THE ENGINE
18.3

Changing the gear oil

Warning
Danger of scalding Engine and gear oil get very hot when the motorcycle is ridden.
–
Wear suitable protective clothing and safety gloves.
–
In the event of scalding, rinse the area affected immediately with lukewarm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the applicable regu-
lations.
Info
Drain the gear oil while the engine is at operating temperature.
Main work
(All 125/150 models)
–
Remove gear oil monitoring screw
–
Check the gear oil level.
A small quantity of gear oil must run out of the drilled hole.
» If no gear oil runs out:
–
–
Mount and tighten the gear oil monitoring screw.
E00367-10
Guideline
Screw, gear oil level check
(125 XC‑W EU)
Screw, gear oil level check
(150 XC‑W US)
(All 250/300 models)
–
Detach the foot brake lever spring.
–
Remove gear oil monitoring screw
–
Check the gear oil level.
A small quantity of gear oil must run out of the drilled hole.
» If no gear oil runs out:
–
–
Mount and tighten the gear oil monitoring screw.
E00366-10
Guideline
Screw, gear oil level check
–
Attach the foot brake lever spring.
Preparatory work
(All Six Days models, EXC AU)
–
Remove the engine guard. (
–
Park the motorcycle on a level surface.
–
Place a suitable container under the engine.

Add gear oil. ( p. 114)

Add gear oil. ( p. 114)
p. 75)
.
M6 8 Nm (5.9 lbf ft)
M6 8 Nm (5.9 lbf ft)
.
M6 10 Nm
(7.4 lbf ft)
112