Kia EV6 2024 Owner's Manual page 408

Driver assistance system
僅 Green ( ) blink: Operating state
僅 Grey ( ) on: Standby state
僅 White ( ) blink: Canceled state
(display only a certain time)
2 Lane line
The lane line is displayed identical to
Highway Lane Change Assist indicator
(1). However, the lane detection avail-
ability will be showed on Standby
state.
3 Green arrow and shade
The green arrow is displayed when a
certain amount of time has passed
after the function has started operat-
ing, and until the lane change has
completed.
4 Message
僅 Message is displayed when the
function does not operate even
though the turn signal lever is used.
僅 Message is displayed when the
function is canceled while operat-
ing.
To turn on Highway Lane Change
Assist
OCV051210L
A: Press OK button to enable Lane
Change Assist
1 Confirm
Highway Lane Change Assist function
will turn on when the following condi-
tions are satisfied.
僅 The Driving Assist button or Lane
Driving Assist button is used to turn
on Highway Driving Assist.
7 90
Highway Driving Assist (HDA)
僅 The OK button is pressed on the
steering wheel while a message ask-
ing to use Highway Lane Change
Assist is displayed on the cluster.
Highway Lane Change Assist
ready to operate
While Highway Lane Change Assist
function is on, the function will be ready
to operate when all the following condi-
tions are satisfied:
僅 Highway Driving Assist is operating
僅 Lane Following Assist is operating
僅 A vehicle in the rear area of your vehi-
cle is detected more than once after
the vehicle is turned on
僅 Your vehicle speed is above 40 mph
(60 km/h)
僅 Hands-off warning is not displayed on
the cluster
僅 Hazard warning flasher is off
NOTICE
僅 While Lane Change Assist function is
turned on (indicator on), Lane Follow-
ing Assist will not cancel even if the
turn signal indicator or hazard warn-
ing flasher is operating.
僅 Lane Change Assist function turns off
automatically when driven in the fol-
lowing road conditions:
- One driving lane
- A road with no structure, such as a
median strip, guardrails, etc.
- There is a pedestrian or cyclist on
the road ahead
僅 When the function is in the ready
state, and vehicle speed is below 35
mph (55 km/h), the function will
change to the standby state.
OwnersManuals2.com